DIY Antenna Trap

This page is for the DIY Antenna Trap project.

Antenna_Trap_V2.step

Parts List:

	Wire
2x	Male Spade Connector
2x	Female Spade Connector
2x	Carabiner
	Magnet Wire
	Capacitor

Construction Instructions:

• Wind your inductor tightly around the 1 inch form (Center piece), aim for slightly more than the correct number of turns. You will fine-tune it by compressing and stretching the coil
• Wire your capacitor(s) in parallel to the inductor, attach them to the arm placed away from the inductor
• Print the Trap structure in any way except vertically, as it will experience severe tensile force when in place. The Z-axis is the weakest axis on typical 3d prints